Home » Thrust Bearings » T-200RG Series

T-200RG Thrust Ball Bearing Series

Auburn Totally Enclosed Style T-200RG Double Grooved Thrust Ball Bearing

The T-200RG Thrust Ball Bearing is enclosed and is recommended for use where maximum carrying capacity is desired but thickness space available is limited.

The balls are retained between two hardened steel races banded together by a mild steel or brass sleeve on the outside diameter. The double grooved raceways provide increased capacity without increasing the overall thickness of the bearing.

The T-200RG Thrust Ball Bearing is available in inch dimensions from 1″ through 5.5″ bore, 3.25″ through 12.25″ OD, and 0.875″ through 2.5″ height.

Please note: the following dimensions are shown in inches.
Other Info & Resources

Mounting Instructions: Generally installed with the fitted bore A centered on the shaft and rotating with it, the clearance bore A’ (the race with the sleeve attached to it) seats against a fixed part of the machine and remains stationary. If installed in a recess, a clearance of 1/8″ or more should be left around the outside diameter B, in case the shaft wears in its journal bearings. If this should happen, the clearance you allowed on the outside diameter will prevent the balls from wedging.